On-Site Installation; Brief Installation Procedure - ABB IRB 920 Product Manual

3.3 On-site installation

3.3.1 Brief installation procedure

Introduction
This procedure is a brief guide when installing the robot for the first time. Also see
Pre-installation procedure on page
First installation
Use these procedures to install the IRB 920.
1
2
3
4
5
6
7
8
Product manual - IRB 920
3HAC075721-001 Revision: C
Action
Transport the manipulator to its intended location.
Install the valid platform or prepare the foundation
for the manipulator.
Lift and secure the manipulator to the plat-
form/foundation.
Connect the manipulator to the controller.
Configure the safety settings.
How to start and run the robot is described in the
product manual for the controller.
Install required equipment, if any.
DANGER
Make sure all safety requirements are met when
performing the first test run.
© Copyright 2022 ABB. All rights reserved.
3 Installation and commissioning
3.3.1 Brief installation procedure
52.
Note
See Lifting the robot on page
See Orienting and securing the ro-
bot on page
See
• Product manual - OmniCore
C30
• Product manual - OmniCore
C90XT
• Product manual - OmniCore
E10
See
• Product manual - OmniCore
C30
• Product manual - OmniCore
C90XT
• Product manual - OmniCore
E10
See
• Product manual - OmniCore
C30
• Product manual - OmniCore
C90XT
• Product manual - OmniCore
E10
57.
65.
55