ABB IRB 920 Product Manual page 809

2
3
4
5
Separating the flange from axis-3 motor sub-assembly
1
Product manual - IRB 920
3HAC075721-001 Revision: C
Action
CAUTION
For robots with protection type Clean Room
Always cut the paint with a knife and grind the
paint edge when disassembling parts of the robot!
See Cut the paint or surface on the robot before
replacing parts on page 118.
DANGER
Make sure that the ball screw is supported with
something.
The sudden drop of the ball screw due the lost of
the axis-3 motor may cause danger.
Remove the screws.
Remove the axis-3 motor sub-assembly and the
timing belt.
Action
DANGER
Make sure that all supplies for electrical power,
hydraulic pressure, and air pressure are turned
off.
© Copyright 2022 ABB. All rights reserved.
5.7.3 Replacing the axis-3 motor sub-assembly
Note
xx2100001178
xx2100001181
Note
5 Repair
Continued
Continues on next page
809