ABB IRB 920 Product Manual page 431

Hide thumbs Also See for IRB 920:

Table of Contents

Removing the lower bellow

Product manual - IRB 920

3HAC075721-001 Revision: C

For robots with protection class IP54 (option 3350-

For robots with protection type Clean Room (op-

tion 3351-1)

Remove the flange with bearing.

Make sure that all supplies for electrical power,

hydraulic pressure, and air pressure are turned

For robots with protection type Clean Room

Always cut the paint with a knife and grind the

paint edge when disassembling parts of the robot!

Cut the paint or surface on the robot before

replacing parts on page

For robots with protection class IP54 (option 3350-

For robots with protection type Clean Room (op-

tion 3351-1)

Loosen the upper bellow clamp by loosening the

screw and pull the clamp apart slightly.

For robots with protection class IP54 (option 3350-

For robots with protection type Clean Room (op-

tion 3351-1)

Remove the bellow from the outer arm.

For robots with protection class IP54 (option 3350-

Clean the bellow from the glue if it will be reused.

5.6.2 Replacing the bellows

xx2100002407

xx2100002408

Continues on next page

Troubleshooting