ABB IRB 920 Product Manual page 443

Removing the upper mechanical stopper
1
2
3
4
Product manual - IRB 920
3HAC075721-001 Revision: C
5.6.3 Replacing the pulley on the ball screw upper position
Action
DANGER
Make sure that all supplies for electrical power,
hydraulic pressure, and air pressure are turned
off.
CAUTION
For robots with protection type Clean Room
Always cut the paint with a knife and grind the
paint edge when disassembling parts of the robot!
See Cut the paint or surface on the robot before
replacing parts on page 118.
Remove the screw.
Remove the mechanical stopper.
Tip
Hold the ball screw to prevent it from dropping.
Or the ball screw may be destroyed.
CAUTION
If the ball screw nut or ball screw spline nut go
out of the screw shaft, the ball screw is destroyed.
Be careful when you do any work that may cause
this.
© Copyright 2022 ABB. All rights reserved.
5 Repair
Continued
Note
xx1800002858
xx1800002859
Continues on next page
443