ABB IRB 920 Product Manual page 367

Inserting the main harness through the axis -1 gearbox position
1
2
3
Product manual - IRB 920
3HAC075721-001 Revision: C
Action
For robots with protection type Clean Room:
Clean the joints that have been opened and wipe
the parts free from particles with spirit on a lint
free. See Cut the paint or surface on the robot
before replacing parts on page 118
Note
After all repair work, wipe the Clean Room robot
free from particles with spirit on a lint free cloth.
Make sure that the robot is at zero position.
Insert the internal harness into the inner arm
through the sleeve of the axis-1 gearbox from the
base.
Tip
Wrap the connectors with the masking tape.
Tip
The air hoses should face the axis-1 motor.
CAUTION
Make sure that no cables or hoses are twisted or
strained. Reroute if necessary.
© Copyright 2022 ABB. All rights reserved.
5 Repair
5.5.1 Replacing the inner arm
Continued
Note
xx2100000930
For rear outlet cable version:
xx2100000955
For undeneath outlet cable version:
xx2100001206
Continues on next page
367