Chapter 11 Summary Of Parameters - Delta CT2000 Series User Manual

Chapter 11 Summary of Parameter Settings
This chapter provides summary of parameter settings for user to gather the parameter setting ranges,
factory settings and set parameters. The parameters can be set, changed and reset by the digital keypad.
NOTE
1） : the parameter can be set during operation
2） For more detail on parameters, please refer to Ch12 Description of Parameter Settings.
00 Drive Parameters
NOTE
IM: Induction Motor; PM: Permanent Magnet Motor
Pr.
00-00
Identity Code of the AC Motor Drive
Display AC Motor Drive Rated
00-01
Current
00-02 Parameter Reset
00-03 Start-up Display Selection

00-04 Content of Multi-function Display

Explanation
Chapter 11 Summary of Parameter SettingsCT2000 Series
Settings
410: 460V, 11kW
411: 460V, 15 kW
412: 460V, 18.5 kW
413: 460V, 22 kW
414: 460V, 30 kW
415: 460V, 37 kW
416: 460V, 45 kW
417: 460V, 55 kW
418: 460V, 75 kW
419: 460V, 90 kW
Display by models
0: No function
1: Parameter write protection
5: Reset KWH display to 0
6: Reset PLC (including CANopen Master Index)
7: Reset CANopen Index (Slave)
9: All parameters are reset to factory settings(base
frequency is 50Hz)
10: All parameters are reset to factory settings
(base frequency is 60Hz)
0: F (frequency command)
1: H (output frequency)
2: U (multi-function display, see Pr.00-04)
3: A (output current)
0: Display output current (A)
1: Display counter value (c)
2: Display actual output frequency (H.)
3: Display DC-BUS voltage (v)
4: Display output voltage (E)
5: Display output power angle (n)
6: Display output power in kW (P)
7: Display actual motor speed rpm (r)
8: Display estimate output torque % (t)
9: Display PG feedback (G) (refer to
Pr.10-00,10-01)
10: Display PID feedback in % (b)
11: Display AVI in % (1.)
12: Display ACI in % (2.)
13: Display AUI in % (3.)
14: Display the temperature of IGBT in oC (i.)
15: Display the temperature of capacitance in oC
(c.)
16: The status of digital input (ON/OFF) (i)
17: The status of digital output (ON/OFF) (o)
11-1
Factory
Setting
Read
only
Read
only
0
0
3