Rep 7.4 Roll Feed Drive Roll - Xerox 8850 Service Manual

1
Remove the two Pinch Roll Springs from
the plastic mounts
3
Remove an E-ring from one end of the
Roll Feed Pinch Roll Shaft to access the
Pinch Rolls
Figure 1 Removing the Roll Feed Pinch Rolls
Repairs and Adjustments
REP 7.3, REP 7.4
2
Remove the Roll Feed
Pinch Rolls and Shaft
03/2003
4-12

REP 7.4 Roll Feed Drive Roll

Parts List on PL 7.1
Switch off the Main Power Switch. Disconnect the Power Cord.
NOTE: All three Roll Feed Drive Roll assemblies are removed the same way.
Removal
1. Remove the appropriate Roll Media Supply Drawer
2. Remove the Feed Clutch (REP 7.5).
3. Remove the Toner Waste Container.
4. (Figure 1): Remove the Roll Feed Drive Roll.
WARNING
(REP 7.1).
8850/ 510DP