Replacing Toothed Belt For Camshaft Drive And Tensioning Pulley; Replacing The V-Ribbed Belt; Replacing Toothed Belt For Coolant Pump; Inspect Toothed Belt For Camshaft Drive And Coolant Pump Drive For Wear And Condition - Skoda Rapid NH 2013 Maintenance, Workshop Manual

3.5 Replacing toothed belt for camshaft
drive and tensioning pulley
– Removing and Installing toothed belt Engine ⇒ Engine; Rep.
gr. 15 .
3.6

Replacing the V-ribbed belt

Removing and installing V-ribbed belt ⇒ Engine; Rep. gr. 13 .
3.7

Replacing toothed belt for coolant pump

Removing and installing V-ribbed belt ⇒ Engine; Rep. gr. 19 .
3.8 Inspect toothed belt for camshaft drive
and coolant pump drive for wear and
condition
⇒ "3.8.1 Inspecting timing belt for camshaft drive for wear and
running", page 59
⇒ "3.8.2 Inspecting toothed belt for coolant pump drive for wear
and running", page 60
3.8.1 Inspecting timing belt for camshaft drive
for wear and running
Work procedure
– Expose vacuum hose on the holder -3-.
– Unscrew bolt -2-.
– Loosen clips -arrows-, remove toothed belt guard -1- upwards.
– Turn the crankshaft on the fixing screw of the belt pulley crank‐
shaft in direction of running of the engine and check the
complete toothed belt for the following conditions -arrows-:
Rapid NH 2013 ➤ , Rapid NH 2014 ➤
Maintenance - Edition 06.2018
59