Optional) Configuring The Active Aging Time For The Original Traffic; Checking The Configuration; Collecting Mpls Traffic Statistics - Huawei S9700 Series Configuration Manual

S9700 Core Routing Switch
Configuration Guide - SPU
5.4.6 (Optional) Configuring the Active Aging Time for the Original
Traffic
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
ipv6 netstream timeout active active-interval
The active aging time is set for the original traffic.
By default, the active aging time of the original traffic is 30 minutes.
----End

5.4.7 Checking the Configuration

Prerequisites
The NetStream configuration is complete.
Procedure
Step 1 Run the display ipv6 netstream all command to view the NetStream configuration.
----End
Example
View the NetStream configuration.
[Quidway]display ipv6 netstream all
system
ipv6 netstream timeout inactive 300
ipv6 netstream export source 6.6.6.1
ipv6 netstream export host 5.0.132.2 10
ipv6 netstream export host 1.1.1.1 20
ip netstream record
test0
match ipv4 source-port
match ipv6 source-address
match ipv6 destination-address
collect counter packets
collect counter bytes
collect interface input
collect interface output

5.5 Collecting MPLS Traffic Statistics

This section describes how to collect statistics about MPLS traffic passing through an interface.
Issue 01 (2012-03-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
5 NetStream Configuration
156