Configuring Mpls - Huawei S9300 Configuration Manual

S9300&S9300E Terabit Routing Switch
Configuration Guide - IP Service
Step 6 Run:
interface interface-type interface-number
The interface view of the IPv6 network is displayed.
Step 7 Run:
ipv6 enable
IPv6 is enabled on the interface.
Step 8 Run:
ipv6 address { ipv6-address prefix-length | ipv6-address/prefix-length } eui-64
Or
ipv6 address { ipv6-address prefix-length | ipv6-address/prefix-length }
The interface is configured with an IPv6 address.
Step 9 Run:
quit
Return to the system view.
----End

11.5.3 Configuring MPLS

This section describes how to configure the basic functions of MPLS including LSP setup and
LDP enabling.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
mpls lsr-id ip-address
The LSR ID is specified.
Step 3 Run:
mpls
MPLS is enabled and the MPLS view is displayed.
Step 4 Run:
quit
Return to the system view.
Step 5 Run:
mpls ldp
MPLS LDP is enabled.
Step 6 Run:
quit
Issue 01 (2012-03-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
11 IPv6 over IPv4 Tunnel Configuration
198