Huawei Quidway S8500 Series Command Manual page 286

Command Manual – Routing Protocol
Quidway S8500 Series Routing Switches
Description
Use the display ip routing-table acl command to view the route filtered through
specified basic access control list (ACL).
This command is used in track display of route policy to display the route that passed
the filtering rule according the input basic ACL number or name.
The command is only applicable to display the route that passed basic ACL filtering
rules.
Example
# Display the summary of Active routes that are filtered through basic acl 2000.
[Quidway] acl number 2000
[Quidway-acl-basic-2000] rule permit source 10.1.1.1 0.0.0.255
[Quidway-acl-basic-2000] rule deny source any
[Quidway-acl-basic-2000] display ip routing-table acl 2000
Routes matched by access-list 2000:
Summary count: 4
Destination/Mask
10.1.1.0/24
10.1.1.2/32
For detailed description of the output information, see Table 1-1.
# Display the verbose information of the Active and Inactive routes that are filtered
through basic acl 2000.
<Quidway> display ip routing-table acl 2000 verbose
Routes matched by access-list 2000:
+ = Active Route, - = Last Active, # = Both
Summary count: 2
**Destination: 10.1.1.0
**Destination: 10.1.1.2
Protocol Pre
DIRECT 0 0
DIRECT 0 0
Protocol: #DIRECT
*NextHop: 10.1.1.2
Vlinkindex: 0
State: <Int ActiveU Retain Unicast>
Age: 7:24 Cost: 0/0
Protocol: #DIRECT
*NextHop: 127.0.0.1
Vlinkindex: 0
State: <NoAdvise Int ActiveU Retain Gateway Unicast>
Huawei Technologies Proprietary
Chapter 1 Static Route Configuration Commands
Cost Nexthop
10.1.1.2 Vlan-interface1
127.0.0.1 InLoopBack0
* = Next hop in use
Mask: 255.255.255.0
Preference: 0
Interface: 10.1.1.2(Vlan-interface1)
Tag: 0
Mask: 255.255.255.255
Preference: 0
Interface: 127.0.0.1(InLoopBack0)
1-3
Interface