Configuring A Radius Server Template; Establishing The Configuration Task - Huawei Quidway S3700 Series Configuration Manual

Quidway S3700 Series Ethernet Switches
Configuration Guide - Security
Prerequisite
The configurations of AAA schemes are complete.
Procedure
l
l
l
l
l
l
----End

1.4 Configuring a RADIUS Server Template

This section describes how to configure a RADIUS server template on the S3700.

1.4.1 Establishing the Configuration Task

Applicable Environment
In remote authentication or authorization mode, you need to configure a server template as
required. You need to configure a RADIUS server template if RADIUS is used in the
authentication scheme.
Pre-configuration Tasks
None
Data Preparation
To configure a RADIUS server template, you need the following data.
Issue 01 (2011-07-15)
Run the display aaa configuration command to check the summary of AAA.
Run the display authentication-scheme [ authentication-scheme-name ] command to
check the configuration of the authentication scheme.
Run the display authorization-scheme [ authorization-scheme-name ] command to check
the configuration of the authorization scheme.
Run the display accounting-scheme [ accounting-scheme-name ] command to check the
configuration of the accounting scheme.
Run the display recording-scheme [ recording-scheme-name ] command to check the
configuration of the recording scheme.
Run the display access-user [ domain domain-name | ip-address ip-address [ vpn-
instance instance-name ] | mac-address mac-address | slot slot-id | interface interface-
type interface-number [ vlan vlan-id [ qinq qinq-vlan-id ] ] | user-id user-number ]
command to check the summary of all online users.
NOTE
There are default parameters of a RADIUS server template, and the default parameters can be changed
according to the networking. You can modify the RADIUS configuration only when the RADIUS server
template is not in use.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
1 AAA and User Management Configuration
10