Icom VE-PG4 Operating Manual page 57

5
BRidgE ConnECtion SEttingS
Bridge Connection screen
Bridge Connection Settings > Bridge Connection
■ Bridge Connection
Unicast mode
L the above example shows when the Bridge Connection destination (2) is set to "Custom Bridge Connection."
Multicast mode
L the above example shows when the Bridge Connection destination (2) is set to "digital transceiver 2 (d-tRX2)."
Transmission Mode ���
3
SelCall in Bridge Connection
4
1
2
3
4
5
6
7
1
2
3
8
Set the transmission mode for Bridge Connection with the RoiP gateway
by either Unicast or Multicast.
Set whether or not you can make an individual call to a device that is
connected to the same network as this RoiP gateway.
L if this setting is enabled, the RoiP gateway connects to the destination
device according to the List of Rule Settings for SelCall in Bridge
Connection.
(Bridge Connection Setttings > SelCall in Bridge Connection > List of Rule
Settings for SelCall in Bridge Connection)
L this setting is displayed when the combination of digital transceiver
(d-tRX1 ~ 4) and the Custom Bridge Connection are set.
9
9
5-3
10
10
(default: disable)