Icom VE-PG4 Operating Manual page 123

6
TRANSCEIvER CoNTRoLLER
Transceiver Settings screen
Transceiver Controller > Transceiver Settings > Transceiver Settings
■ Transceiver Settings
Firmware Server �����
55
SYSLOG Host IP Address
56
SYSLOG Severity ����
57
Read/Write Password ��
58
<Apply> ��������
59
<Reset> ��������
60
51
52
53
54
55
56
57
58
Enter an IP Address or Host name of the Firmware Server for the
IP100H, of up to 63 characters.
L When the RoIP Gateway is used as its Firmware Server, this entry is not
necessary.
Enter the SYSLOG host's address.
L The host device must have the SYSLOG server function.
Select the log information to send to the SYSLOG host. The SYSLOG
host is sent to another host that is set in the [SYSLOG Host IP Address]
(56).
L Enter a check mark to send the log entries.
Enter a password of up to 16 characters. The password is used when
reading from, or writing to the IP100H, or updating the firmware using
the CS-IP100H*.
* CS-IP100H is the cloning software for the IP100H, and can be
downloaded from the Icom website.
Click to apply the entries.
L Some parts of the entries are displayed in [Transceiver Setting List], such
as the Transceiver Model, Name, Unit ID, Use ID List, Area Call, Message,
Status, and Option Key.
Click to reset the settings.
L You cannot reset after clicking <Apply>.
6-52
59 60
(Default: M DEBUG M INFo M NoTICE)