Table of Contents
Advertisement
7
CONNECTION PORT SETTINgS
EXT I/O (EXT) screen
Connection Port Settings > EXT I/O (EXT)
■ Transceiver Connection
These items are displayed when "Transceiver" is selected as a connected unit.
(Connection Port Settings > EXT I/O (EXT) > EXT I/O Port Mode > EXT I/O 1 ~ 4 > Connected Unit)
(Connection Port Settings > EXT I/O (EXT) > EXT I/O > EXT I/O Port)
Server Address
25
Server Port Number
26
Baud Rate
27
Data Bits
28
Parity
29
Stop Bits
30
Flow Control
31
Connection Status
32
Session Timer
33
Transceiver Model: general Setting
Enter a destination RoIP gateway's IP address.
Enter a destination RoIP gateway's port number between 1024 and
65535.
(Default: EXT1=50000, EXT2=50001, EXT3=50002, EXT4=50003)
Select the serial communication baud rate between a device and the
RoIP gateway.
Select the number of bits for serial communication.
Select the parity bit.
Select the stop bit length.
Select the Flow control option.
Click to connect or disconnect the transceiver, or to refresh the
connection status.
L The buttons are grayed out when Connected Repeater's Address is blank.
L The settings cannot be changed while connection is established. Click
<Disconnect> before changing the settings on this screen.
Set the time to cut the TCP session when there is no communication
from the host.
7-26
(Default: 9600)
(Default: 8)
(Default: none)
(Default: 1)
(Default: None)
(Default: 30)
Advertisement
Chapters
Table of Contents
