Icom VE-PG4 Operating Manual page 133

6
TRANSCEIvER CoNTRoLLER
ID List screen
Transceiver Controller > Common Settings > ID List
■ ID List Common Settings
Select an ID list that the IP100Hs will use.
L You can individually specify an ID list to the groups that the IP100Hs belong to in [Profile] on the [Common Settings]
screen.
L If any entries on this screen have been changed, you must reboot the IP100H.
ID List Common Setting Number
Transceiver Controller > Common Settings > ID List
■ ID List Advanced Settings
Enter the group name that is selected in [ID List Common Settings].
Name ����������
1
<Apply> ��������
2
<Reset> ��������
3
Select the group number between 1 and 50, and then enter IDs that the
IP100Hs will use.
L When the group name or IDs are registered in the group, they are displayed
as shown below.
1
Enter a group name of up to 31 characters.
The group is selected in [ID List Common Setting] on the [ID List]
screen.
When the group is selected on the [ID List] and [Profile] screens, the
group name is displayed.
Click to apply the entries.
Click to reset the settings.
L You cannot reset after clicking <Apply>.
6-62
2 3