Icom VE-PG3 Installation Instructions Manual

PRECAUTIONS
RoIP GATEWAY
IMPORTANT
READ ALL INSTRUCTIONS carefully
and completely
before using the VE-PG3.
—
SAVE THESE INSTRUCTIONS
These instructions
contain important safety and operating instructions for the
VE-PG3.
PRECAUTIONS
■ For the VE-PG3
R WARNING! NEVER
use other than the specified AC
adapter. This may result in an electrical shock, cause a fire
or damage the VE-PG3.
R WARNING! NEVER
use non-specified accessories or
options. This may result in an electrical shock, cause a fire
or damage the VE-PG3.
R WARNING! NEVER
connect the AC adapter to other
than the [DC] jack on the VE-PG3 rear panel. This may
result in an electrical shock, cause a fire or damage the
VE-PG3.
R WARNING! NEVER
disassemble, modify or repair the
VE-PG3. This may result in an electrical shock, cause a fire
or damage the VE-PG3.
R WARNING! NEVER
install the VE-PG3 in a wet place
or outside. This may result in an electrical shock, cause a
fire or damage the VE-PG3.
R WARNING! NEVER
operate or touch the VE-PG3 with
wet hands. This may result in an electrical shock or damage
the VE-PG3.
R WARNING! NEVER
connect the ground terminal to a
gas or electric pipe. This may result in an electrical shock or
cause a fire.
R WARNING! NEVER
use the VE-PG3 during a thunder
and lightening storm. Using it may result in an electrical
shock, cause a fire or damage the VE-PG3. Always
disconnect the AC adapter before any storm.
R WARNING!
Immediately disconnect the AC adapter
if the VE-PG3 emits an abnormal odor, sound or smoke.
Contact your Icom dealer or distributor for advice.
Thank you for purchasing this Icom product. The VE-PG3
RoIP GATEWAY is designed and built with Icom's IP
network technology. We hope you agree with Icom's
philosophy of "technology first." Many hours of research
and development went into the design of your VE-PG3.
EXPLICIT DEFINITIONS
WORD DEFINITION
Personal injury, fire hazard or electric
RWARNING!
shock may occur.
Equipment damage may occur.
CAUTION
If disregarded, inconvenience only. No risk
NOTE
of personal injury, fi re or electric shock.
CAUTION: NEVER put the VE-PG3 in any unstable place
(such as on a slanted surface or vibrated place). This may
cause injury and/or damage to the VE-PG3.
CAUTION: NEVER install the VE-PG3 in a place without
air vents. Heat dissipation may be reduced, and this could
damage the VE-PG3.
CAUTION:
Always place the VE-PG3 in a secure place to
avoid inadvertent use by children.
CAUTION: DO NOT
use or place the VE-PG3 in areas
with temperatures below 0ç (+32ƒ) or above +40ç
(+104ƒ).
CAUTION: DO NOT
place the VE-PG3 in direct sunlight.
This could damage the VE-PG3.
CAUTION: DO NOT use the VE-PG3 in strong magnetic
fields or in an area with high static electricity. This could
damage the VE-PG3.
CAUTION: Disconnect the AC adapter when you will not
use the VE-PG3 for a long period of time.
CAUTION: DO NOT
use harsh solvents such as benzine
or alcohol to clean the VE-PG3, as they can damage the
VE-PG3's surfaces. If the VE-PG3 becomes dusty or dirty,
wipe it clean with a dry, soft cloth.
CAUTION:
Use only the specified cable to connect a
transceiver or repeater to the VE-PG3. Using another cable
could cause damage to the VE-PG3 or to the transceiver or
repeater.
PRECAUTIONS
■ For the AC adapter
R WARNING! NEVER
use other than the VE-PG3. This
may result in an electrical shock, cause a fire or damage
the AC adapter.
R WARNING!
Connect the adapter into an outlet
between 100 V and 240 V AC. Otherwise, this may result in
an electrical shock, cause a fire or damage the AC adapter.
R WARNING! NEVER
install the AC adapter to wet place
where is outside or near the humidifier. This may result in an
electrical shock, cause a fire or damage the AC adapter.
R WARNING! NEVER
put something heavy on the AC
adapter cable. This may result in an electrical shock, cause
a fire or damage the AC adapter.
R WARNING! NEVER
modify, bend by force, twist,
pull or heat the AC adapter's cable. This may result in an
electrical shock, cause a fire or damage the AC adapter.
R WARNING! NEVER
touch the AC adapter with wet
hands. This may result in an electrical shock or damage the
AC adapter.
R WARNING! NEVER
use the AC adapter when it can
not closely insert into the AC outlet. This may result in an
electrical shock, cause a fire or damage the AC adapter.
R WARNING!
Use and place the AC adapter and
connection cable to avoid inadvertent use by children. This
may result in an electrical shock or cause injury .
■ Other precautions
• When operating the PC or external device, see those
instruction manuals for details.
• The supplied AC adapter may at some time need to be
replaced, depending on its life expectancy. The life of
an AC adaptor differs according to the environment or
condition in which the adaptor is used.
We recommend replacement when it has been used for
approximately 5 years (When used under the ambient
temperature of 25 °C; 77°F). Contact your local dealer for
details.
• VE-PG3 supports only IPv4. IPv6 is not supported.
ABOUT THE OPTIONAL CONNECTION CABLE
Before connecting cables, see the cable's manual and the
sticker on the bottom of the VE-PG3 for port information.
• Verify that both the VE-PG3 and connected devices are
turned OFF when connecting or disconnecting the cable.
• Hold the connector body when connecting or
disconnecting them.
• When other cables are connected, you can use needle-
nose pliers to carefully insert or remove connectors.
• Never bend or pinch the cable.
• Never place a heavy object on the cable.
• Never touch the cable with wet hands.
• Always connect the cable correctly. An incorrect connection
could damage the VE-PG3 and/or the transceiver.
FCC INFORMATION
CAUTION: Any changes or modifications not expressly
approved by the party responsible for
compliance could void the user's authority
to operate the equipment.
NOTE:
This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to part 15
of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause
harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more
of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and
receiver.
• Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician
for help.
ABOUT CE
This equipment complies with the essential
requirements of the 2004/108/EC directive for
Electromagnetic Compatibility.
Port information on the sticker
Sticker
VE-PG3 （bottom view）
Connection cable （optional）