Table of Contents
Advertisement
6
TRANSCEIvER CoNTRoLLER
Wireless LAN screen
Transceiver Controller > Common Settings > Wireless LAN
■ Wireless LAN
7
Channel ��������
4
Power Level �������
5
1
2
3
4
5
6
8
Select the channel that you want to scan when the IP100H uses 2.4
GHz (11g).
L When you specify a channel, select "Static" in the [Channel], and specify a
channel that you use in [Static Channel].
Set the IP100H transmit power level to High, Middle or Low.
L When "High" is set, the transmission distance of the IP100H is maximum.
Or when setting to a lower level, the distance will be reduced.
L Power Level is set to a lower level when you want to:
• Reduce the communication range.
• Limit the communication area and improve security.
• Reduce electrical interference among Wireless LAN transceivers.
• Control the communication speed in an environment where some access
points are installed in a comparatively small area.
9
11
6-55
10
12
(Default: Automatic (1-13))
(Default: High)
Advertisement
Chapters
Table of Contents
