Icom VE-PG4 Operating Manual page 246

9
ExPERT SETTINGS
Abnormal Condition Monitoring screen
Expert Settings > Abnormal Condition Monitoring
■ PING Test
Set the monitor function for a communication error.
~ are displayed only when Monitoring (1) is set to "Enable."
2 4
L
Monitoring �������
1
Control Output �����
2
IP Address �������
3
Monitoring Period ����
4
1
2
3
4
Select whether or not to send PING commands to the host specified by
the IP address. When the error is detected, the error is displayed on the
"SYSLOG" screen. (Information > SYSLOG >SYSLOG)
Select whether or not to short the B1/B2 terminal (+/–) to output an
error detect signal.
L Confirm the Relay Circuit is selected.
( Connection Port Settings > ExT I/O (ExT) > ExT Output Settings >
Switching Control)
Enter the destination IP address to send the PING commands to.
Set the monitor period.
• Range: 1 ~ 4320 (minutes)
9-4
(Default: Disable)
(Default: Disable)
(Default: 10)