Icom VE-PG4 Operating Manual page 122

6
TRANSCEIvER CoNTRoLLER
Transceiver Settings screen
Transceiver Controller > Transceiver Settings > Transceiver Settings
■ Transceiver Settings
Provisioning Server ���
51
Accept Reboot Command from
52
Other than the Master Controller Select whether or not the IP100Hs can be rebooted by the other than
SNTP Server ������
53
Automatic Firmware Updating
54
at Power ON ������
51
52
53
54
55
56
57
58
Enter an IP address or Host name of the Provisioning Server for the
IP100H, of up to 63 characters.
L When the RoIP Gateway is used as its Provisioning Server, this entry is not
necessary.
the specified Provisioning server (51).
L The RoIP Gateway and IP1000C are compatible with this function.
(As of May, 2019)
Enter the IP address of the device that is specified as the SNTP server
for the IP100H.
L When the RoIP Gateway is used as its SNTP Server, this entry is not
necessary.
Select whether or not the IP100H will use the Automatic Update function.
• Disable
Disables the automatic firmware updating when the IP100H is turned ON.
• Enable (without Automatic Reboot)
When this setting is set to "Enable (without Automatic Reboot)," the
IP100H works as follows.
1. The IP100H confirms the latest firmware in the RoIP Gateway
when it is turned ON.
2. The IP100H automatically downloads the firmware if it needs to be
updated.
3. The IP100H will be updated when it is turned ON again.
• Enable (with Automatic Reboot)
When this setting is set to "Enable (with Automatic Reboot)," the
IP100H works as follows.
1. The IP100H confirms the latest firmware in the RoIP Gateway
when it is turned ON.
2. The IP100H automatically downloads the firmware if it needs to be
updated.
3. The IP100H is updated automatically, and then it is rebooted.
L You can check the firmware version of the IP100H on the [TOP] menu.
6-51
59 60
(Default: Enable (with Automatic Reboot))
(Default: Disable)