Icom VE-PG4 Operating Manual page 143

6
TRANSCEIvER CoNTRoLLER
Status screen
Transceiver Controller > Common Settings > Status
■ Status Settings
Select to register a status that the IP100Hs use.
L You can program statuses of up to 32 characters. You can enter up to 10 statuses.
L If any entries on this screen have been changed, you must reboot the IP100H.
1
Check Box �������
1
<Apply> ��������
2
<Reset> ��������
3
Click a Check Box to display a status name on the IP100H.
L When the box is not checked, the status name is not displayed on the
IP100H, even if you entered it.
When the status name is not entered, the status number is displayed on the
IP100H only if the box is checked.
L You can check or uncheck them all at once by clicking [All].
Click to apply the entries.
Click to reset the settings.
L You cannot reset after clicking <Apply>.
6-72
2 3