Icom VE-PG4 Operating Manual page 145

6
TRANSCEIvER CoNTRoLLER
Profile screen
Transceiver Controller > Common Settings > Profile
■ Profile
Individually assign an ID list, message list or receive notification tone to the group that the IP100H belongs to.
L After the setting is completed, you must reboot the IP100H.
No. �����������
1
Name ����������
2
Wireless LAN ������
3
ID List ���������
4
Message List ������
5
1
2
3
4
5
Select a profile between 1 and 50, to assign to the group that IP100H
belongs to.
Enter a profile name of up to 31 characters.
The profile name is displayed in [Profile List] on the [Profile] screen.
Select the wireless LAN setting that is commonly used by the IP100Hs
in the group.
• Transceiver's Setting
Uses the last wireless LAN setting that was set by the CS-IP100H or
the RoIP Gateway.
• 1 (Name) to 20 (Name)
Select a number that was entered on the [Wireless LAN] screen.
Select an ID list that is commonly used by the IP100Hs in the group.
L Select an ID number that is registered on the [ID list] screen.
Select a Message list that is commonly used by the IP100Hs in the group.
L Select a message number that is registered in [Messages].
6-74
(Default: Transceiver's Setting)
(Default: 1)
(Default: 1)