Icom VE-PG4 Operating Manual page 52

4
RouTER SETTINGS
VPN screen
Router Settings > VPN
■ IPsec Tunnel Settings
Set the virtual private network (VPN) connection using the IPsec tunnel.
Tunnel Interface �����
1
Tunnel ���������
2
Tunnel Name ������
3
Interface ��������
4
Authentication Key
5
(Pre-Shared Key) ����
Remote Address ����
6
1
2
3
4
5
6
7
8
Specifying the interface to register the IPsec tunnel.
Range: vti0 ~ vti31
Select "Enable" to use the IPsec tunnel to register.
Select "Disable" when it is registered but not used.
Enter the name to identify the IPsec tunnel of up to 31 characters.
Select the interface to connect with Remote Address.
• eth0
Select this interface when "Static IP" or "DHCP client" is set in the
"Connection Type" setting (Router Settings > WAN > Connection
Type).
• ppp0(WAN01) ~ ppp7(WAN08)
Select this interface when "PPPoE(WAN01 ~ WAN08)" is set in the
"Connection Type" setting (Router Settings > WAN > Connection
Type).
L "WAN01 ~ WAN08" are the nicknames.
To authenticate the VPN Remote peer, enter the same character strings
as the connected device of up to 128 alphanumeric characters.
Enter the IP address or the host name of the VPN connection destination.
When the IP address or the host name is entered, the RoIP Gateway
initiates a VPN connection to the connected device.
L If this item is not set, the RoIP Gateway only works as a responder that waits
for a connection from other devices.
4-25
9
10
(Default: Enable)
(Default: eth0)