Icom VE-PG4 Operating Manual page 357

13
PBX EXTEnSIon
Converter Bridge screen
PBX Extension > Converter Bridge
■ Communication
The settings to communicate between the RoIP gateway and a converter bridge connection destination.
L The screen shows when both Encryption and Talkback are enabled.
Encryption �������
1
TalkBack ��������
2
Call Type ��������
3
Dstination Prefix ID ���
4
Destination ID ������
5
Source ID ��������
6
1
2
3
4
5
6
Select "Enable" to encrypt the communication.
When you select "Enable," enter the appropriate key in "Encryption
Key."
• Range: 1 ~ 32767
L This setting takes effect when the AMBE+2 codec is used.
Commonly used by the transceivers that belong to a group set in the
RoIP Gatway. Set the period of time from when the transceiver finishes
transmitting until the screen returns to the standby mode.
• Range: 1 ~ 10 (seconds)
Set the call type to send from a SIP phone to a transceiver that belongs
to the Converter Bridge connection destination.
• options: Individual, Group, or All
Enter the prefix ID of the destination.
• Range: Blank or 0 ~ 30
L The range differs, depending on the system settings
Does not displayed when the Call Type (3) is set to "All."
Enter an Individual ID or Group ID of the destination transceiver, that is
entered into the Converter Bridge connection destination.
• Range: When the Prefix is not set:
When the Prefix is set:
Enter an Individual ID or Group ID of the caller.
This ID will be announced at the call destination.
• Range: 1 ~ 9999999
13-64
(Default: Disable)
(Default: Group)
(Default: Blank)
1 ~ 9999999
1 ~ 99999
(Default: 5)
(Default: 1)
(Default: 1)