Icom VE-PG4 Operating Manual page 212

7
CONNECTION PORT SETTINgS
RoIP gateway screen
Connection Port Settings > RoIP gateway
■ RoIP gateway Connection
is displayed only when the Transmission Mode (1) is set to "Multicast."
6
L
Source Port Number
4
Voice Protocol
5
Multicast TTL
6
Connection Status
7
1
1
2
3
4
5
6
7
Enter a port number to receive an audio signal.
L Used as a source port number for an audio signal.
L Enter a port number between 1024 and 65534, in even number.
L Do not conflict with the other port settings.
L Enter the port number between 2 and 65534, in even number.
L Do not conflict with the other port settings.
L In the Multicast mode, all the default setting are "25210."
Displays the Voice Protocol Selected in the
"Voice Protocol (For Custom Bridge Connection)"
(Bridge Connection Settings > Bridge Connection >
AMBE+2 Vocoder Assignment >
Voice Protocol (For Custom Bridge Connection))
Enter the Time to Live value (TTL). TTL is used to control the Multicast
packet delivery scope. Every time the packets pass through the router,
this value subtracted. When the value is "0," the packets are discarded.
• Range: 1 ~ 255
Click to connect or disconnect the RoIP gateway, or to refresh the
connection status.
L The buttons are grayed out when Connected Repeater's Address is blank.
L The settings cannot be changed while connection is established. Click
<Deactivate> before changing the settings on this screen.
( Default for RoIP gateway1: 24400)
( Default for RoIP gateway2: 24402)
( Default for RoIP gateway3: 24404)
( Default for RoIP gateway4: 24406)
( Default for RoIP gateway5: 24408)
( Default for RoIP gateway6: 24410)
( Default for RoIP gateway7: 24412)
( Default for RoIP gateway8: 24414)
7-58
(Default: 1)