Icom VE-PG4 Operating Manual page 116

6
TRANSCEIvER CoNTRoLLER
Transceiver Settings screen
Transceiver Controller > Transceiver Settings > Transceiver Settings
■ Transceiver Settings
(This is an example of when the [Lone Worker] (42) is set to "Enable.")
Lone Worker Reminder Timer
44
Lone Worker: Enable
PTT Delay ��������
45
Lone Worker: Enable
NOTE:
The RoIP Gateway should not be used when high reliability is necessary.
The communication cannot be made, depending on the environment around the RoIP Gateway, such as the
consumption of a battery, the signal environment, or the access point or network status.
Use the [Emergency] and [Lone Worker] functions as a supplementary function.
41
42
43
44
45
Enter the period of time to start the Emergency call transmission
after the period of time that is set in [Lone Worker ON Timer] (43) has
passed.
When the transceiver is not operated after the period of time has
passed, the Emergency call automatically starts.
• Range: 1 ~ 255 (seconds) in 1 second steps
L When the transceiver is operated by the [Emergency] function activation,
[Lone Worker ON Timer] and [Lone Worker Reminder Timer] are reset.
L When the [Lone Worker Reminder Timer] is activated, beeps sound every 2
seconds until the timer is reset.
Enter the period of time for the delay time to transmit by pushing [PTT]
while [Lone Worker On Timer] and [Lone Worker Reminder Timer] are
activated.
• Range: 1 ~ 255 (×100 milliseconds)
L If this item is set to a longer period of time, you can reset [Lone Worker On
Timer] and [Lone Worker Reminder Timer] by momentary pushing [PTT]
without transmitting.
L Hold down [PTT] for more than the set period of time in this item to transmit.
6-45
(Default: 60 (seconds))
(Default: Enable, 10)