Icom VE-PG4 Operating Manual page 397

14
PBX ADVANCED SETTINgS
DID screen
PBX Advanced Settings > DID
■ DID Settings
Sets the details when using the DID (Direct Inward Dialing) function.
L The above screen shows when Action (4) is set to "Call Default Destination."
Index ����������
1
Response Time �����
2
Dial Tone ��������
3
Action ���������
4
Default Call Destination
5
Number ��������
Timer ����������
6
<Apply> ��������
7
<Reset> ��������
8
About the DID operation
After the set period of time in Timer (6) has passed without any operation since starting the Dial Tone, the
DID starts the Action (4).
L You can immediately dial by pushing "#" without waiting for 5 seconds of digit interval timer.
L When dialing an incomplete phone number that does not include a DID number, the call will be canceled after the
Busy Tone sounds.
1
2
3
4
5
6
Select a DID that you want to edit its settings.
Set the delay time to sound a Dial Tone (3) since an inbound call has
arrived.
• Range: 0 ~ 10 (seconds)
Selects the tone pattern that sounds on an IP phone. (Default: Type 1)
• Options: Type 1 ~ 3
Select the timeout action of the RoIP gateway when the particular
period of time (6) has passed without receiving any DTMF signal.
• Clear Down:
• Call Default Destination: Makes a call to the Default Call Destination
Displayed only when Action (4) is set to "Call Default Destination." Set
the Destination phone number.
Enter the time period for timeout timer.
• Range: 0 ~ 120 (seconds)
L When setting this item to "0," the timeout timer does not work.
L The timer will be expired when a DTMF signal is detected.
Click to apply the entries.
Click to reset the settings.
L You cannot reset after clicking <Apply>.
14-31
7 8
Cancels the call without calling the client
transceiver.
Number (5).
(Default: DID 1)
(Default: 4)
(Default: Clear Down)
(Default: 10)