Table of Contents
Advertisement
6
TRANSCEIvER CoNTRoLLER
Transceiver Settings screen
Transceiver Controller > Transceiver Settings > Transceiver Settings
■ Transceiver Settings
Emergency Alert Tone ��
37
Emergency: Enable
Call type ��������
38
Emergency: Enable
Cancel on Reply �����
39
Emergency: Enable
Cancel by Time �����
40
33
34
35
36
37
38
39
40
Select whether or not to sound an alarm when an Emergency call is sent.
When this item is set to "Disable," "Emergency" is not displayed on the
screen, and IP100H sends the Emergency call.
When "Enable" is selected, set the [Emergency Alert Tone Volume]
(audio level) of the alarm to between 0 and 32.
Select the call type of Emergency call from Individual, Group, All, or
Telephone.
If you select "Individual" or "Group," enter the 4 digit Destination ID. If
you select "Telephone," enter a Destination Phone Number of up to 31
characters (0–9, #, and *).
Select whether or not to cancel the Emergency call when any RX code
is received.
Select whether or not to cancel the Emergency call after the set period
of time has passed.
If you select "Enable," enter a period of time to between 1 and 255 seconds.
6-43
(Default: Enable)
(Default: 32)
(Default: All)
(Default: Enable)
(Default: Disable)
(Default: 60 (seconds))
Advertisement
Chapters
Table of Contents
