Vanderbilt SPC4 Series Installation & Configuration Manual page 71

SPC4xxx/5xxx/6xxx – Installation & Configuration Manual
The expander that is connected to the power supply within the G5 is set to ID1 by default. This setting
should not be changed.
Number Name
1 Optional
wireless
module
2 SPC status
LEDs
3 Clock
Reference
© Vanderbilt 2018
Description
The controller PCB can be factory fitted with a wireless module for use with wireless
(868MHz) sensors.
These 7 LEDs display the status of various system parameters as described in
Controller status LEDs on page 368.
A clock reference signal can also be applied to this 2-pin connector to maintain accurate
system time.
Connect to Clock Reference CN17 on SPCP355.300 Smart PSU.
71
Controller hardware
A6V10276959-d
12.09.2018