Vanderbilt SPC4 Series Installation & Configuration Manual page 132

SPC4xxx/5xxx/6xxx – Installation & Configuration Manual
Name Description
KEY POSITIONS Enables you to assign behaviour to specific key positions for specific areas.
Select an area for the key position, and assign one of the following options to that area:
16.6.4.5 Edit Door Controllers
For further information about Door controllers, see Door Expander on page 74.
1. Scroll to DOOR CONTROLLERS > EDIT.
2. Press SELECT.
3. Scroll to the device to be edited and press SELECT.
Parameters and details, if applicable, are displayed for editing as shown in the table below.
DESCRIPTION
DOORS
READERS
To edit a DOOR I/O:
1. Scroll to DOORS.
2. Press SELECT.
3. Scroll to the DOOR I/O to be edited and press SELECT.
Parameters and details, if applicable, are displayed for editing as shown in the table below.
ZONES
DOOR 1 – DOOR
64
If the option "ZONES" is selected for a DOOR I/O the two inputs of this door I/O must be configured:
To edit the two zones of a DOOR I/O:
1. Scroll to the DOOR I/O to be edited and press SELECT
The option "Zones" is selected.
2. Press SELECT.
3. Select which Zone should be edited (DPS or DRS zone).
© Vanderbilt 2018
None
l
Unset
l
Partset A
l
Partset B
l
Fullset
l
Toggle Unset/Fullset
l
Toggle Unset/Partset A
l
Toggle Unset/Partset B
l
All Okay
l
Setting Authorisation
l
No access functionality is realized. The inputs and outputs can be
used normally.
The selected door number is assigned to the DOOR I/O.
Name of the door controller
Configuration of Door I/O 1 and Door I/O 2.
Configuration of Reader Profiles
132
Engineer programming via the keypad
A6V10276959-d
12.09.2018