Vanderbilt SPC4 Series Installation & Configuration Manual page 264

SPC4xxx/5xxx/6xxx – Installation & Configuration Manual
System
Restriction
Option
Web Only Zone Tamper
Policy
Web Only Keypad Display
Policy
Web Only Keypad LED
Policy
Web Only System
General Policy
Web Only Confirmed
Alarms System
Alerts
Hold-up Data
Web Only Hold-up
keyword 1
Web Only Hold-up
keyword 2
Web Only Phone number
1
Web Only Phone number
2
*A WPA is compatible with SiWay RF Kit (SPCW110, 111, 112, 114 ) only.
See also
Adding/Editing an area on page 273
17.10.3.2 Timers
This page gives an overview about identified timer defaults and their description.
These settings, which vary depending on the defined Security Grade of the system, should only be
programmed by an authorised installation engineer. Changing settings could render the SPC system
noncompliant with security standards. Setting the Security Grade back to EN 50131 Grade 2 or EN
50131 Grade 3 overwrites any changes made on this page.
© Vanderbilt 2018
Description
Select whether particular zone tampers can be restored, inhibited or isolated by
the user and engineer.
Select events to be displayed on keypads in both Set and Unset modes.
Select which LEDs will be displayed on keypads in both Set and Unset modes.
Select options to manage remote control of the system and alarm and bell
settings from the following:
- No confirmed alarms if internally set
- Block remote restore
- Block remote isolates
- Block remote inhibits
- No external bell if internal set
- Delay reporting if entry active
- Confirmed alarm cancels delay
Select which system alerts cause a confirmed alarms when at least one alarm
is active, and which system alerts cause the panel to enter the tentative state.
Enter the first hold-up keyword to send to the CMS in a Holdup Information
(HD) event.
Enter the second hold-up keyword to send to the CMS in a Holdup Information
(HD) event.
Enter the first site phone number to send to the CMS in a Holdup Information
(HD) event.
Enter the second site phone number to send to the CMS in a Holdup
Information (HD) event.
264
Engineer programming via the browser
A6V10276959-d
12.09.2018