Vanderbilt SPC4 Series Installation & Configuration Manual page 293

SPC4xxx/5xxx/6xxx – Installation & Configuration Manual
Performable actions
Add Add conditions for the trigger. Click this button to add one or more conditions for the selected
trigger. See Trigger conditions below.
Exceptions Configure setting schedules for exceptional circumstances outside of the normal weekly
schedules.
Edit/View Edit or view the selected calendar.
Delete Delete the selected calendar.
The calendar cannot be deleted if it is currently assigned to an SPC configuration item, i.e. zone,
area, user profile, output, trigger, door or X-Bus component. A message is displayed indicating the
assigned item.
Trigger conditions
The following table lists the trigger conditions and the associated States, Outputs, Events, or
Communication.
Trigger
States, Outputs, Events, or Communications
condition
Zone The trigger is ON if the following conditions are satisfied (i.e. a logical AND operation is
performed): The trigger is ON if the configured zone is in one of the following states - Open,
Close, Short, or Disconnected.
Door The trigger is ON if the any of the following door options are configured: Entry granted, Entry
denied, Exit granted, Exit denied, Door open too long, Door left open, Door forced
open, Door normal, Door Locked, Door unlocked.
Output The trigger is ON if the system output is in the configured state, which can be On or Off:
System Output, Mapping gate, Area Output.
System The trigger is ON for the chosen system event and ID. IDs are: System Reboot, Overcurrent,
Engineer Access, Manufact. Access, XBUS cable fault, Xbus faults.
Time Trigger – the trigger is on at the specific time entered in the box provided, in the format
hh:mm.
© Vanderbilt 2018 293
Engineer programming via the browser
A6V10276959-d
12.09.2018