Vanderbilt SPC4 Series Installation & Configuration Manual page 190

SPC4xxx/5xxx/6xxx – Installation & Configuration Manual
Wireless The number of the sensor enrolled on the system (1 = first, 2 = second, etc.).
Sensor
ID A unique identity number for that sensor.
Type The type of wireless sensor detected (magnetic contact, inertia/shock, etc.).
Zone The zone to which the sensor has been enrolled.
Battery The status of the battery in the sensor.
Supervise The status of the supervisory operation (OK = supervisory signal received, Not Supervised = no
supervisory operation).
Signal The signal strength received from the sensor (01 = low, 09 = high).Note: Although it is not possible to
enroll a device with a signal strength less than 3, devices whose signal drops below 3 after enrolment are
not dropped.
Version The version details of the sensor.
Performable actions
Log
Enrol New Sensor
Refresh
Edit
Remove
17.6.3.2 Log - Wireless sensor X
To view a quick log of events for a wireless sensor:
1. Click the Log button in the table row for that sensor.
2. The Message log for the sensor displays.
3. Optionally, you can create a text file of the log by clicking Text File.
Information provided in the message log
Time The date and time of the logged event.
Receiver The wireless receiver location, that is, wireless module mounted on the keypad,
controller or wireless expander.
Signal The signal strength received from the sensor (01=low, 09=high).
Status The physical status of the sensor.
Battery The status of the battery connected to the sensor (OK, Fault).
© Vanderbilt 2018
Click to view the wireless sensor Log. See Log - Wireless sensor X below.
Click to enrol a new sensor.
Click to refresh the list of enrolled sensors.
Click to edit the sensor attributes.
Click to remove the sensor from the enrolled sensors list.
190
Engineer programming via the browser
A6V10276959-d
12.09.2018