Vanderbilt SPC4 Series Installation & Configuration Manual page 345

SPC4xxx/5xxx/6xxx – Installation & Configuration Manual
Peripheral Firmware Upgrade
Upgrade the peripheral firmware using the same procedure as for the controller firmware.
The peripheral firmware file is only stored temporarily in the file system. When a new peripheral
firmware file is uploaded, the current and new versions of the firmware for each peripheral and modem
is displayed as shown:
Click the Upgrade button for the peripherals that require upgrading or click the Upgrade All
l
button to upgrade all peripherals.
If the firmware for a peripheral device in the pfw file is older than the existing firmware of that
device, a Downgrade button is available.
During upgrade, the panel checks if the firmware in the peripheral file supports the particular hardware
versions of the installed peripherals and does not allow an upgrade for those peripherals which are not
supported.
If the pfw file version differs from the controller version, a warning message is displayed
If the major version number of the firmware available for a device differs from the existing major number
of a device, a warning message is also displayed.
Upgrading the SPCP355.300 Smart PSU Firmware
To upgrade the SPCP355.300 Smart PSU you must ensure the following:
The mains power must be connected.
l
The SPCP355.300 Smart PSU firmware can only be updated through the browser.
The upgrade procedure can take up to 2 minutes to complete. Do not perform any actions within
the browser, restart or shut down the system until the upgrade completes. A message will be
displayed when the process is complete.
See also
Adding/Editing User Profiles on page 200
17.12.1.2 Upgrading Languages
A custom language file (*.clng) can be uploaded to the panel.
© Vanderbilt 2018 345
Engineer programming via the browser
A6V10276959-d
12.09.2018