Vanderbilt SPC4 Series Installation & Configuration Manual page 224

SPC4xxx/5xxx/6xxx – Installation & Configuration Manual
17.9.2.2 Set additional two-way wireless attributes
Depending on the sensor type, additional two-way wireless attributes can be configured by clicking the
Edit button beside the sensor in the Enrolled Sensors List.
PIR
To program the attributes for a PIR:
1. Select Configuration > Hardware > Wireless Settings.
2. Click the Edit button beside the desired PIR.
Programmable attributes for PIR
Sensor
Description
Sensor Type
Zone
Zone Type
Area
LED
© Vanderbilt 2018
The number of the sensor as enrolled on the system (1 = first, 2 = second, etc).
Text description of the sensor.
The type of wireless sensor detected (e.g. magnetic contact, PIR).
The zone number to which the sensor has been enrolled.
The type of zone (e.g. Alarm, Entry/Exit).
Areas to which the zone is assigned.
When enabled, the LED will come on when the PIR is activated.
224
Engineer programming via the browser
A6V10276959-d
12.09.2018