Vanderbilt SPC4 Series Installation & Configuration Manual page 280

SPC4xxx/5xxx/6xxx – Installation & Configuration Manual
There are three ways to delay setting:
1. Entering the PIN on the keypad.
DELAY is a menu option on the standard keypad. The buttons at the top of the comfort keypad are
used to operate the delay feature
2. Using the keyswitch.
Turning the key to the right delays setting the system by the configured delay if the maximum
number of times that setting can be delayed (Delay Counter) has not been exceeded. Turning the
key to the left sets the delay to three minutes (non-configurable). This can be done regardless of
how many times setting was delayed.
3. Using a FOB, WPA or button which activates a Delay Autoset trigger action.
Temporary Unset
To allow a system to be temporarily unset in a time period specified by a calendar, the following three
parameters need to be configured:
1. Calendar
A calendar needs to be configured and selected for this area.
2. Time Locked
This box needs to be ticked so that the area can be unset only when allowed as per the configured
calendar.
3. Unset Duration
This parameter needs to be set to a value greater than zero to set an upper limit on the time the area
will be unset.
All Okay
All Okay If selected, user must confirm 'All okay' input or silent alarm is generated. See Editing a zone on
Required page 272 for details on configuring an 'All Okay' zone input.
All Okay Time (in seconds) in which 'All okay' must be confirmed before alarm is raised. (Range: 1–999
Time seconds)
All Okay Select the event type to be sent when the 'All okay' timer expires. Options are Panic (Silent), Panic
Event and Duress.
RF Output
RF Output Time
Fire Exit Route
Fire exit Select the doors which will open when fire occurs in this area. This option does not display in
route domestic mode.
© Vanderbilt 2018
Enter the number of seconds that the RF Output will remain on for.
0 seconds will toggle the output on and off.
280
Engineer programming via the browser
A6V10276959-d
12.09.2018