Installing The Batteries - Vanderbilt SPC4 Series Installation & Configuration Manual

SPC4xxx/5xxx/6xxx – Installation & Configuration Manual
WARNING: If the tamper bracket screw is not secure against the wall, then tamper protection is
compromised.

6.3.3 Installing the batteries

If using two batteries in the G5 housing, it is recommended that both batteries should be the same
Ah rating.
Number Description
1 Battery
2 Fixing strap
3 Battery fixing tabs
4 Strap holes
5 Battery leads
To install the batteries:
1. Place the batteries into the battery compartment.
2. Press the metal tabs at the top and either side of the batteries in towards the batteries.
3. Secure each battery to the housing using a battery strap. Ensure that the strap is thread through
the battery strap holes at the back of the battery compartment and around the battery, with the
two ends of the strap at the front of the battery.
4. Fasten the two ends of the strap firmly using the Velcro strip. Ensure that the strap is tight
© Vanderbilt 2018
Number Description
6 Battery temperature lead
7 PSU
8 Optional expander positions
9 Controller
10 Antenna
55
Mounting system equipment
A6V10276959-d
12.09.2018