Vanderbilt SPC4 Series Installation & Configuration Manual page 304

SPC4xxx/5xxx/6xxx – Installation & Configuration Manual
Operator Multi-network SIMs only
Survey
Enable this option for the modem to search for all available networks and to connect to the
strongest available signal.
Allow Select to enable GSM roaming.
Roaming
Warning: If this option is enabled, the modem can connect to a network in a different country.
Note: Changing this setting resets the modem.
Note: Supported on GSM modems v3.08 or higher.
USSD Pay-As-You-Go SIM only
Enter the code that the modem can use to query the network for the credit balance of the SIM.
This code is network-dependent, please check with your service provider.
Incoming Note: Vanderbilt recommend that these options are not enabled for current systems.
Calls
The modem can be programmed to answer calls based on the following conditions:
Don't answer incoming calls: The modem never answers calls.
l
Answer incoming calls: The modem answers incoming calls.
l
Only answer when 'Engineer Access' is granted: The modem only answers the call
l
while engineer access is granted to the system.
Line Disabled
l
Monitoring
Enable
l
Fullset
l
Enable this feature to monitor the signal level from the GSM mast connected to the modem.
The Fullset option only enables this feature while the system is Fullset.
Note: EN 50131-9 Confirmation configuration — In order for EN50131-9 Confirmation to
operate correctly, line monitoring must be enabled. (See Options on page 255.)
Monitoring Enter the time period in seconds for which the signal level must drop to Low before the SPC
Timer system registers a fault. 0 to 9999 seconds range.
Modem Fault Enter the time delay in seconds before the SPC system sends an alert. 0 to 9999 seconds
Time range.
SMS Enable Tick this checkbox to enable the transmission and reception of SMS messages and command
control.
Automated Disabled
l
SMS
1 hour
l
24 Hours
l
48 Hours
l
7 Days
l
30 Days
l
Select the timing for automated SMS messages.
Automated Enter SMS number to receive automated SMS messages. Only one device can receive these
SMS Number messages.
© Vanderbilt 2018 304
Engineer programming via the browser
A6V10276959-d
12.09.2018