Vanderbilt SPC4 Series Installation & Configuration Manual page 305

SPC4xxx/5xxx/6xxx – Installation & Configuration Manual
Start Enter the start date and time from when the system will send automated SMS messages.
Date/Time
Mobile Data Configuration
Access Point Enter Access Point details to enable any IP communications. These details are service
(APN) provider-dependent.
Access Point Enter Access Point details to enable any IP communications. These details are service
User Name provider-dependent.
Access Point Enter Access Point details to enable any IP communications. These details are service
Password provider-dependent.
Dial Up Internet Configuration
Dial Up Select this option to enable the modem to gain internet access through a dial-up connection
Internet
Enable
Phone Enter the phone number for the dial-up connection.
Number
Username Enter the dial-up connection Username.
Password Enter the dial-up connection Password.
Click the Test SMS button to send a short text message for the purposes of testing the system.
The SMS test is provided only for the purpose of ensuring the SMS feature is operating correctly. A
short text message using alphabetic characters (A-Z) should be used to test this feature.
PSTN modem
1. Select Communications > Communications > Modems.
2. Click Configure.
3. Configure the fields as described in the table below.
PSTN Modem settings
Country Select the country that the SPC is installed in.
Incoming The modem can be programmed to answer calls based on the following conditions:
Calls
Don't answer incoming calls Modem never answers calls.
l
Answer after 'x' rings Select the number of rings (1 to 8) after which the modem answers
l
the incoming call.
Answer when after one ring phone is hung up, then immediately dialled again If the
l
calling party calls the modem, hangs up after 1 ring burst only, and then immediately re-calls
the modem. The SPC system knows to automatically answer the call in this condition.
Only answer when engineer access is granted The modem only answers the call while
l
engineer access is granted to the system.
Prefix Enter the number required to access a line (for example, if connected to a PBX).
© Vanderbilt 2018 305
Engineer programming via the browser
A6V10276959-d
12.09.2018