Vanderbilt SPC4 Series Installation & Configuration Manual page 352

SPC4xxx/5xxx/6xxx – Installation & Configuration Manual
The web server on the controller can be accessed via a remote connection over the GSM network. A GSM
module (with SIM card) must be installed on the controller as shown above to provide remote access to the
SPC. The data option of the SIM card must be activated and the data number must be used.
On the remote side of the connection the user must have a PSTN or GSM modem installed on a PC with
browser. If a PSTN modem is installed then it must be connected to a working PSTN line.
To connect remotely to the controller:
1. Install a GSM modem on the controller (see the corresponding installation instructions).
2. Enter Full Engineer programming from the keypad and configure the modem (primary or backup) to
answer an incoming call.
3. On the keypad, scroll to the following menu: FULL ENGINEER > COMMUNICATION > MODEMS,
and select the settings listed:
Enable Modem
Type
Country Code
Answer Mode
Modem Rings
On Windows XP:
1. Open the New Connection Wizard by browsing to Control Panel > Network Connections >
Create New Connection (in the Network Tasks window).
2. On the Network Connection Type window, select Connect to the Internet.
3. On the Getting Ready window, choose Setup my connection manually.
4. On the Internet Connection window, choose Connect using Dialup modem.
5. On the Connection Name window enter the connection name, for example, SPC remote
connection.
6. On the Phone Number to Dial window, enter the phone number of the GSM line connected to the
GSM modem.
7. On the Connection Availability window, choose whether this connection is available to all users.
8. On the Internet Account Information window, enter the following details:
- Username: SPC
- Password: password
- Confirm Password: password
The Completing the New Connection Wizard page is displayed.
9. Click Finish to save the Dial-up connection to the PC.
To activate this dial-up connection:
Click the icon located on the Control Panel > Network Connections page.
l
The PC makes a data call to the GSM line connected to the SPC GSM module.
The SPC GSM module answers the incoming data call after the designated number of rings and
establishes an IP link with the remote computer.
The SPC system automatically assigns an IP address to the remote PC.
© Vanderbilt 2018
Set to Modem Enabled.
Displays the type of modem (GSM).
Select the relevant country code.
Select numbered rings; this tells the modem to wait for a number
of rings before answering the incoming call.
Select the number of rings to allow before answering the call (8
rings max).
352
Accessing web server remotely
A6V10276959-d
12.09.2018