Sms Commands - Vanderbilt SPC4 Series Installation & Configuration Manual

SPC4xxx/5xxx/6xxx – Installation & Configuration Manual
4. Configure the SMS details as follows:
SMS ID
User
SMS
Number
SMS
Events
SMS
Control
NOTICE: HOLDUP alarm events are not transmitted via SMS.
If the phone line is connected to the PSTN network via a PBX, the appropriate line access digit
should be inserted before the called party number. Ensure that Calling Line Identity (CLI) is
enabled on the line selected to make the call to the SMS network. Consult the PBX administrator
for details.

17.8.4 SMS Commands

When the SMS setup and configuration is complete, SMS features may be activated. Commands,
depending on SMS configuration, are sent using a PIN or caller ID. The type of PIN depends on what is
set for SMS Authentication.
The table below provides all available SMS commands. Subsequent action and response are also
provided.
SMS Commands are sent as texts to the phone number of the SIM card on the controller.
For commands using a PIN, the format of the text is:
© Vanderbilt 2018
System generated ID.
Select a new user for this SMS ID if required.
Enter the number to which the SMS will be sent (requires three-digit country code
prefix).
Note: Engineer SMS number can deleted by resetting it 0. User SMS numbers
cannot be deleted.
Select the panel events which the user or engineer will receive via SMS.
Select the operations that the user or engineer can perform remotely on the panel
through SMS. See SMS Commands below.
205
Engineer programming via the browser
A6V10276959-d
12.09.2018