Vanderbilt SPC4 Series Installation & Configuration Manual page 342

SPC4xxx/5xxx/6xxx – Installation & Configuration Manual
Ethernet Tick this box to allow SPC Connect PRO to connect over Ethernet.
TCP
Port
USB
Serial 1
(X10)
Modem
1
17.11.4.2 SPC Manager
The SPC manager mode setting determines the number of digits for user PINs and therefore the number of
available PINs on a global system controlled by SPC Manager.
Mode41: 4-digit PIN enables 1,000 global users
Mode51: 5-digit PIN enables 10,000 global users
Mode61: 6-digit PIN enables 100,000 global users
Mode71: 7-digit PIN enables 1000,000 global users
Mode81: 8-digit PIN enables 10,000,000 global users
When you set an SPC Manager mode, additional zeros are added to the front of existing 4 or 5 digits user
PINs which modify the PIN for global use. For example, if Mode71: 7-PIN Digit is selected, 3 zeros are
added to existing 4 digit PINs – 2222 will become 0002222.
To set the SPC Manager Mode:
1. Select Communications > PC Tools > SPC Manager.
2. Select the SPC Manager global user mode from the drop down list.
3. Click the Save button.
The mode cannot be saved if a conflict exists between a local existing user PIN and another user
PIN on the global system. An 'Invalid PIN' error is displayed.
4. Click the appropriate button to delete the PIN and save the new mode or change the PIN to the
randomly generated new PIN displayed and then save the new mode.
NOTICE: SPC Manager modes cannot be changed if global users exist on the system.
© Vanderbilt 2018
Enter the TCP port on which the panel listens to incoming connections from SPC
Connect PRO.
Tick this box to allow SPC Connect PRO to connect over USB.
Tick this box to allow SPC Connect PRO to connect over Serial 1 (X10).
Tick this box to allow SPC Connect PRO to connect over Modem 1.
342
Engineer programming via the browser
A6V10276959-d
12.09.2018