Vanderbilt SPC4 Series Installation & Configuration Manual page 319

SPC4xxx/5xxx/6xxx – Installation & Configuration Manual
ATP Sequence
No.
ATP Unique ID
ATP Name
SPT Account
Code
ARC Connection
Number 1
Number 2
Modem Select
Test Calls
Test Call Mode
(Non-active
ATP)
Test Call Mode
(Active ATP)
Time of first test
call
Event Protocol
© Vanderbilt 2018
This field displays the sequence number of the ATP in the ATS
configuration. Number 1 is primary, numbers 2–10 are backup
This ID uniquely identifies the ATP to the RCT
Enter a name for the ATP
Enter a number to uniquely identify the panel to the RCT (1–999999)
Phone number 1
Phone number 2
Select the modem to be used.
Modem 1
l
Modem 2
l
Select the mode for sending test calls when the ATP is in non-active mode.
Default: 24 hours.
Test calls disabled
l
Test call every 10 minutes
l
Test call every 1 hour
l
Test call every 24 hours
l
Test call every 48 hours
l
Test call every 7 days
l
Test call every 30 days
l
Select the mode for sending test calls when the ATP is an active ATP.
Default: 24 hours.
Test calls disabled
l
Test call every 10 minutes
l
Test call every 1 hour
l
Test call every 24 hours
l
Test call every 48 hours
l
Test call every 7 days
l
Test call every 30 days
l
Time of first test call after reset or ATS initialization.
Send Immediately (default)
l
or
Select a half hour interval between 00:00 and 23:30
l
319
Engineer programming via the browser
A6V10276959-d
12.09.2018