Vanderbilt SPC4 Series Installation & Configuration Manual page 245

SPC4xxx/5xxx/6xxx – Installation & Configuration Manual
Change
function
Audible Indications
Alarms
Entry/Exit
Key press
Deactivation
Calendar
Mapping
gate
Keyswitch Select if indication module should be limited by a keyswitch.
Keypad
Card
reader
3. Configure the input.
WARNING: Your system will not comply with EN standards if you enable a function key to set the
system without a valid PIN being required.
Configuring a Keyswitch Expander
1. Select Settings > X-Bus > Expanders.
2. Click one of the keyswitch identifying parameters.
© Vanderbilt 2018
Click this button to change the function for this indicator. The function can be
enabled or used for a system, area, zone or keyswitch.
Select if the alarms should be audible.
Select if entry/exit should be audible.
Select if keypress should be audible.
Select if indicator expander should be limited by calendar.
Select if indicator module should be limited by a mapping gate.
Select if indicator module should be limited to a valid PIN entered on a keypad.
(see warning above)
Select if indicator module should not be activated until a valid card/fob is
presented to the built-in card reader.
245
Engineer programming via the browser
A6V10276959-d
12.09.2018