Vanderbilt SPC4 Series Installation & Configuration Manual page 301

SPC4xxx/5xxx/6xxx – Installation & Configuration Manual
2. Configure the fields as described in the table below.
IP
address
IP
Network
Gateway
IP
Address
Enable
DHCP
DNS
Server
17.11.1.3 Configuring Modems
The SPC panel provides two on-board modem interface connectors (primary and backup) that allow
you to install GSM and/or PSTN modules onto the system.
After a factory default, during the process of initial setup of the system with the keypad, the panel
detects if it has a primary or backup modem fitted, and if so, it displays the modem type and
automatically enables it (or them) with the default configuration. No other modem configuration is
allowed at this stage.
To program the modem(s):
Note: A modem must be installed and identified. (See section Installing plug-in modules on page 90.)
1. Select Communications > Communications > Modems.
© Vanderbilt 2018
Enter the IP address of the panel.
Enter the subnet mask that defines the type of network address structure
implemented on the Local Area Network (LAN).
Enter the IP address of the IP gateway if one exists. This is the address that IP
packets will be routed through when accessing external IP addresses on the
internet.
Click this Button to enable dynamic address assignment on the panel.
Enter the IP address of the DNS server.
301
Engineer programming via the browser
A6V10276959-d
12.09.2018