Vanderbilt SPC4 Series Installation & Configuration Manual page 269

SPC4xxx/5xxx/6xxx – Installation & Configuration Manual
2. Configure the fields as described in the table below.
Installation
ID
Installation
Name
Installation
Date
Installer
Name
Installer
Phone
Display
Installer
Engineer
Lock
Engineer
Lock PIN
17.10.3.4 Standards
All alarm systems must comply with defined security standards. Each standard has specific
security requirements that apply to the market/country in which the alarm system is installed.
© Vanderbilt 2018
Enter a unique number for each installation This number identifies the
installation (1–999999).
Enter the name of the installation. An installation name must be entered before
the installation is saved on the system. The installation can be viewed from
the keypad.
Select the date from the dropdown menu that the installation was completed.
Enter the name of the person who installed the system (for support purposes).
Enter the contact phone number of the person who installed the system (for
support purposes).
Tick this box to display the installation details on the keypad connected to the
panel when in the idle condition.
Tick this box to require use of the engineer lock PIN to factory default the
panel.
Enter value for lock PIN (4 digits).
269
Engineer programming via the browser
A6V10276959-d
12.09.2018