Vanderbilt SPC4 Series Installation & Configuration Manual page 247

SPC4xxx/5xxx/6xxx – Installation & Configuration Manual
Change function
Deactivation
Calendar
Mapping gate
Output
Output x
Keyswitch Functions
Centre, Right and
Left Positions
WARNING: Your system will not comply with EN standards if you enable a keyswitch function to
set the system without a valid PIN being required.
17.10.2.2 Keypads
Editing a Standard Keypad
1. Select Configuration > Hardware > X-Bus > Keypads.
2. Click one of the standard keypad identifying parameters.
© Vanderbilt 2018
Click this button to change the function for this indicator. The function can
be enabled or used for a system, area, zone or keyswitch.
Select if the keyswitch module should be limited by calendar.
Select if the keyswitch module should be limited by a mapping gate.
Configure and text the outputs for the keyswitch. See Editing an output on
page 233 for more details.
Select the Function that that this keyswitch position will perform and the
relevant Area.
Keyswitch functions are:
None
l
Unset
l
Partset A
l
Partset B
l
Fullset
l
Toggle Unset / Fullset
l
Toggle Unset / Partset A
l
Toggle Unset / Partset B
l
All Okay
l
Setting authorisation
l
Shunt
l
247
Engineer programming via the browser
A6V10276959-d
12.09.2018