Vanderbilt SPC4 Series Installation & Configuration Manual page 150

SPC4xxx/5xxx/6xxx – Installation & Configuration Manual
Name Description
Zone The door position sensor input can be used for the intrusion part as well. If the door position
sensor input is used also for the intrusion part, the zone number it is assigned to has to be
selected. If the door position sensor is used only for the access part, the option "UNASSIGNED"
has to be selected.
If the door position sensor is assigned to an intrusion zone, it can be configured like a normal zone
but only with limited functionality (for example, not all zone types are selectable).
If an area or the system is set with the card reader, the door position sensor input has to be
assigned to a zone number and to the area or the system which have to be set.
Description Description of the zone the door position sensor is assigned to.
(Web only)
Zone Type Zone type of the zone the door position sensor is assigned to (not all zones types are available).
(Web only)
Zone The attributes for the zone the door position sensor is assigned to can be modified.
attributes
(Web only)
Area The area the zone and the card reader are assigned to. (If the card reader is used for setting and
unsetting, this area will be set/unset).
(Web only)
Door The resistor used with the door position sensor. Choose the used resistor value/combination.
Position
(Web)
DPS End
Of Line
(keypads)
DPS Select if the door release switch is to be a normally open or normally closed input.
Normal
Open
Door The resistor used with the door release switch. Choose the used resistor value/combination.
Release
(Web)
DRS END
OF LINE
(Keypads)
DRS Select if the door release switch is a normally open input or not.
Normal
Open
No DRS Select to ignore DRS.
(Web only) If a DC2 is used on the door, this option MUST be selected. If not selected, the door will open.
Reader Select the location of the entry and exit readers.
Location
(Entry/Exit)
(Web only)
© Vanderbilt 2018 150
Engineer programming via the keypad
A6V10276959-d
12.09.2018