Vanderbilt SPC4 Series Installation & Configuration Manual page 160

SPC4xxx/5xxx/6xxx – Installation & Configuration Manual
NOTICE: After a factory default, during the process of initial setup of the system with the keypad,
the panel detects if it has a primary or backup modem fitted, and if so, it displays its type and
automatically enables it (or them) with the default configuration. No other modem configuration is
allowed at this stage.
16.13.3.2 Configuring Modems
To configure a GSM or PSTN modem:
1. Scroll to MODEMS and press SELECT.
2. Toggle between PRIMARY and BACKUP for correct modem slot and press SELECT.
The ENABLE MODEM option is displayed.
3. ENABLE or DISABLE the modem as required.
4. Scroll to MODEM STATUS, TYPE, FIRMWARE VERSION and SIGNAL LEVEL and press
SELECT to view details of the modem.
5. Configure the following modem settings from the menu as follows and press ENTER after each
selection:
Menu Option Description
COUNTRY Select a country from the list.
CODE
GSM PIN (GSM modem only) Enter a GSM PIN for the SIM card.
ANSWER Select to select the mode in which the modem answers incoming calls: NEVER ANSWERS
MODE or ALWAYS ANSWERS.
ANSWER Select ENABLE to only answer when engineer access is granted.
ENG. ACC.
SETUP SMS Select ENABLE SMS to enable SMS for this modem.
PSTN modem only
Select SMS SERVER to enter an appropriate phone number of the SMS service provider that
is accessible in your location, if required. This number automatically displays the default
number for SMS for the country selected.
To manually test SMS, select TEST SMS and enter the SMS NUMBER.
To automatically test SMS at specific time intervals, select
AUTOMATIC TEST, select a TEST INTERVAL and enter the SMS NUMBER.
PREFIX PSTN modem only
DIALLING
Enter a prefix number to include before the SMS number, if required.
© Vanderbilt 2018 160
Engineer programming via the keypad
A6V10276959-d
12.09.2018