Vanderbilt SPC4 Series Installation & Configuration Manual page 330

SPC4xxx/5xxx/6xxx – Installation & Configuration Manual
5. Configure the fields as described in the table below.
Description Enter a description of the remote Alarm Receiving Centre.
Account
Protocol
Priority
Number 1
Number 2
Dial
Attempts
Dial Delay
Dial
Interval
Test Calls
Test All
6. Click the Add button to enter those details on the system.
A list of the configured ARC accounts will be displayed in the browser along with the account
information, description, protocol, dial-up status and time and date of the last call to the ARC.
Editing an ARC filter using SIA or CID
To configure the events on the SPC that will trigger the call to the ARC:
© Vanderbilt 2018
Enter your account number. This information should be available from the
receiving station and is used to identify you each time you make a call to the
ARC.
For a Contact ID account, a maximum of 6 characters is allowed.
Enter the communication protocol that you intend to use (SIA, SIA Extended,
Contact ID, Fast Format).
Note: SPC supports the extended SIA protocol. Select this protocol to support
additional textual descriptions of the SIA events being sent to the Alarm
Receiving Station.
Select the priority for the ARC in terms of primary or back-up reporting.
Enter the first number to be dialled to contact the ARC. This system will always
attempt to contact the ARC on this number before attempting another number.
Enter the second number to be dialled to contact the ARC. The system will only
attempt to contact the ARC on this number if the first contact number did not
successfully establish a call.
Enter the number of times that the system will attempt to make a call to the
receiver. (Default is 8)
Number of seconds to delay between failed dial attempts (0–999).
Enter the number of seconds to delay between failed dial attempts. (0–999)
Enable the test call by choosing a time interval. This will send out an automatic
test call from modem 1 to the primary ARC.
Check this box if you want to initiate also an automatic test call from modem 2 to
the backup ARC.
330
Engineer programming via the browser
A6V10276959-d
12.09.2018